ATTESA (4WD) Fault Codes

[Squeak]

If the 4WD light does not go off, take a look at the LED lamp in the ETS control unit below the rear parcel shelf. It will flash to reveal a fault code; i.e. it may flash 9 times revealing a fault code of 9.

Below is a list of ATTESSA Fault Codes, ATTESSA Pro (V-Spec) may differ.


1 Right front wheel speed sensor or circuit
2 Left front wheel speed sensor or circuit
3 Right rear wheel speed sensor or circuit
4 Left front wheel speed sensor or circuit

5 ABS right front wheel actuator solenoid or circuit
6 ABS left front wheel actuator solenoid or circuit
7 ABS rear wheel actuator solenoid or circuit
8 ABS actuator motor, motor relay or circuit
9 ABS actuator relay or circuit

10 ETS control unit power supply or circuit

11 Fore-and-aft G sensor 1 or circuit
12 Fore-and-aft G sensor 1 or circuit
13 Fore-and-aft G sensor 1, fore-and-aft G senstor 2
14 G sensor power supply 1 or circuit
15 G sensor power supply 2 or circuit
16 Lateral G sensor or circuit

17 Air bleed connector or circuit

18 ETS pressure switch or circuit
19 ETS motor, motor relay or circuit

20 ETS solenoid or circuit
21 Throttle sensor or circuit
22 ETS oil level switch or circuit

23 -

24 or ON ETS control unit, ground or circuit




Data Source: R32 GTR service manual