![]() | |
![]() | |
| |||||||
| Technical / Tuning In need of advice? Or to ask something technical? This is the place |
![]() |
| | LinkBack | Thread Tools | Display Modes |
| | #1 |
| Has stopped squeaking Administrator Membership No. 395 | HICAS Diagnostic Mode There is a HICAS warning light in the instrument cluster. If it comes, on it is indicative of a problem. R32: Check the HICAS oil level (power steering reservoir in some models, or a remote reservoir accessible from the boot) R32 and R33: Check all HICAS electrical connections, and if the light remains on, follow the diagnostic below. Note that having an aftermarket steering wheel fitted without the appropriate HICAS boss adaptor can also cause the HICAS system to show a fault. Switch ignition off, transmission in neutral or auto in Park. Start engine Very quickly (with a couple of seconds), turn the steering wheel left and right about 20 degrees from centre five times, and then pump the brakes five times, then press the brake pedal once more this will enter diagnostic mode. Drive forwards or backwards about 5 metres at a speed less than 10km/hr, this will enter full diagnostic mode. The HICAS light in the instrument cluster will be flashing quickly (for normal) or will flash a code indicating any problems. Long flash = first digit, short flash = second digit. Diagnostics will return to normal after five minutes, or any speed over 10km/hr, or ignition is turned off. HICAS Diagnostic Codes 1989-1993 1 HICAS solenoid right hand 2 HICAS solenoid left hand 3 Cut off valve 4 Power steering solenoid 5 Vehicle speed sensor 6 Steering angle sensor 7 Neutral position sensor 8 (Auto) Parking brake sensor, (Manual) Clutch sensor 9 (Auto) Inhibitor switch, (Manual) Neutral sensor HICAS Diagnostic Codes 1993-1999 11 HICAS control unit 12 HICAS motor power supply not present 13 HICAS motor output not present 21 Vehicle speed sensor not present 22 Steering angle sensor not present 23 Steering angle sensor neutral or not present 24 Rear main sensor input not present 25 Rear sub sensor input not present 31 Parking brake sensor input not present 32 (Auto) Inhibitor switch input not present; (Manual) Neutral switch input not present 33 Engine speed signal not present |
|
__________________ Skyline Owners Club - UK based owners club for all marques of the Nissan Skyline Video Channel - Videos of past events & meets, Trackdays, Santapod & Driveout's Want to buy a banner ad or trade on the forum? Find out the details here. | |
| | |
| | #2 |
| Aministrator Club Member Membership No. 766 Join Date: Jan 2006 Location: in the cellar County: Outside UK Drives: a liner
Posts: 1,659
| has anyone ever tried this and succeeded? I've now given up. The neighbours must think I'm deranged, wildly turning steering wheel and driving up and down and its getting me nowhere. |
|
__________________ Dont have a year off, you get deleted | |
| | |
| | #4 |
| Aministrator Club Member Membership No. 766 Join Date: Jan 2006 Location: in the cellar County: Outside UK Drives: a liner
Posts: 1,659
| |
|
__________________ Dont have a year off, you get deleted | |
| | |
| | #6 |
| Has stopped squeaking Administrator Membership No. 395 | Surely this wouldnt work if you don't have the standard ECU? that may be your problem? |
|
__________________ Skyline Owners Club - UK based owners club for all marques of the Nissan Skyline Video Channel - Videos of past events & meets, Trackdays, Santapod & Driveout's Want to buy a banner ad or trade on the forum? Find out the details here. | |
| | |
| | #8 |
| Has stopped squeaking Administrator Membership No. 395 | haha I meant Steve ![]() |
|
__________________ Skyline Owners Club - UK based owners club for all marques of the Nissan Skyline Video Channel - Videos of past events & meets, Trackdays, Santapod & Driveout's Want to buy a banner ad or trade on the forum? Find out the details here. | |
| | |
| | #9 |
| Aministrator Club Member Membership No. 766 Join Date: Jan 2006 Location: in the cellar County: Outside UK Drives: a liner
Posts: 1,659
| I have the e-manage (piggyback) so still got standard ecu. It definitely wont flash for me in the instrument cluster, I've now given up! |
|
__________________ Dont have a year off, you get deleted | |
| | |
| | #10 |
| Skyline Enthusiast Registered User Join Date: Sep 2008 Location: Trinidad Drives: Nissan Skyline R34 GTT
Posts: 37
| Check and make sure your light isn't blown as well. |
| | |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ditching HICAS system? | 320horses | Skyline Questions | 27 | 4th December 2008 10:15 PM |
| Hicas, Slip & Engine Check Light | Bubble | Technical / Tuning | 23 | 17th November 2007 05:27 PM |
| Can you turn HICAS on after it has been locked ? | sky | Skyline Questions | 14 | 7th September 2007 12:23 AM |
| 18" Alloys & HICAS | Deggers | Wheels / Tyres / Brakes / Suspension | 2 | 24th June 2007 11:17 AM |
| FS: HICAS Lock Out Bar | ISJ | Parts For Sale | 7 | 1st May 2007 04:40 PM |